Welcome to Smart Home Forum by FIBARO
Dear Guest,
as you can notice parts of Smart Home Forum by FIBARO is not available for you. You have to register in order to view all content and post in our community. Don't worry! Registration is a simple free process that requires minimal information for you to sign up. Become a part of of Smart Home Forum by FIBARO by creating an account.
As a member you can:
- Start new topics and reply to others
- Follow topics and users to get email updates
- Get your own profile page and make new friends
- Send personal messages
- ... and learn a lot about our system!
Regards,
Smart Home Forum by FIBARO Team
Question
Olosi 1
Hello,
Have installed a roller shutter 2 to my blind, inclusion was ok but calibration a little weird since if I started it with the blind fully closed the motor went only up and down, while if I start the calibration from blind fully opened it does the full cycle but reversed indeed (not up down up but down up and down).. this results in having the wrong position on the z-wave hub.
The hub shows fully opened when it is closed and vice-versa..
When I push the buttons on the wall it moves correctly down, goes down and up goes up...
Could it be a wrong wiring ? if not any advice ?
Thanks
Link to comment
Share on other sites
2 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.