Double Switch 2 does not report energy

[ogs 0]

From all my Double Switches 2 one seems to be wrong. All reports energy change immediately when I turn light on/off however the one does not report at all. Only way to get the reports is to set interval where are other works without the interval. Any ideas?

 

[Fabir 67]

@ogs

So far, I never had an issue with a Double switch 2 on Energy reporting. Did you try remove it and include again?

 

Make sure Groupe 1 is associated with HC2

 

Best Regards

Fabir

Edited March 8, 2019 by Fabir

[ogs 0]

Thanks, I removed it and include again and it helped.

[Ambiani 0]

I have the same issue.

All my other Fibaro products report energy consumption without any troubles.

But the last one I added only reports consuption on on/off event.

Tried removing and adding it again, but still no luck, is there anything else I can try? (It is connected via Homey)

 

Params:

zw_node_id	"30"
zw_manufacturer_id	"271"
zw_product_type_id	"515"
zw_product_id	"4096"
zw_secure	"✓"
zw_battery	"⨯"
zw_device_class_basic	"BASIC_TYPE_ROUTING_SLAVE"
zw_device_class_generic	"GENERIC_TYPE_SWITCH_BINARY"
zw_device_class_specific	"SPECIFIC_TYPE_POWER_SWITCH_BINARY"
zw_firmware_id	"531"
zw_application_version	"3"
zw_application_sub_version	"3"
zw_hardware_version	"3"
zw_wakeup_interval	0
zw_wakeup_enabled	false
zw_group_1	"1.1"
zw_group_2	"1"
zw_group_3	"1"
zw_group_4	"1"
zw_group_5	"1"
switch_type	"2"
save_state	true
power_report_interval	3600
energie_report_interval	3600
own_power	false
s1_power_report	20
s1_kwh_report	1
energy_alwayson	false
zw_configuration_value	""

 

 

 

Capability	Type	Value	Edit value	Last Updated
measure_power	number	11.2		3 hours ago
meter_power	number	1.33		3 hours ago
onoff	boolean	true		3 hours ago