Temperature reading for Qubino Flush On/Off thermostat

[ollehlund 0]

I have some Qubino Flush On/Off Thermostats for controlling electric floor heating. I'm using the HC2 with 4.580 SW.

My problem is the frequency of reading the actual temperature from Fibaro room sensors, the temperature is only updated once per hour.

I have asked for support from Qubino and from Fibaro but no solution offered. From Fibaro it was promissed that the template for these thermostats would be included in the next update but when that (4.580) was rolled out a few weeks later the support for these thermostats were still missing.

Anyone having a clue how to get the temperature reading updated more frequently?

[FHC2N 3]

Have you tried changing some parameters manually, like parameter 120 for the qubino.

Then you have under devices, advanced - polling time. Have you tried changing that one?

 

 

[ollehlund 0]

14 hours ago, FHC2N said:

Have you tried changing some parameters manually, like parameter 120 for the qubino.

Then you have under devices, advanced - polling time. Have you tried changing that one?

 

 

Yes. Since I have an external battery operated temperature sensor, parameter 120 is not valid. Parameter 121 is set at "2" and parameter 122 is at "17", which is the node of the external temperature sensor. Further I have set the following parameters: #40 = 10; #42 = 300; #43 = 1001; #44 = 1

As mentioned neither Qubino nor Fibaro are able to assist. From Fibaro they said that the next update would include some improvement for these thermostats but that didn't come true as there is no change after the latest update!

The polling is just the controller reading the actual values from the device. My problem is the device updating the readings from the sensor.

Edited March 26, 2020 by ollehlund
Addition