Heat Controller FGT-001 firmware update 4.7 fail - file size error

[jgilabert 0]

Trying to upgrade from version 4.5 to version 4.7 I get the following error:

Status: fail - file size error. contact fibaro support.

[person2000 1]

@jgilabert I face the same problem. Have you been able to solve the problem in the meanwhile? 

 

I am more and more frustrated by fibaro. Literally everything you try from Fibaro fails at first and you find yourself spending hours to solve the problems they should have solved before selling it to the market. You have posted your question on June 20 - with no answer for more than 2 months. @fibaro, are you dead or alive? 

Please login or register to see this attachment.

Edited August 30, 2020 by person2000
abcd

[Flash 103]

Hi @person2000 and @jgilabert,

 

Stop all scenes.

make sure no alarms are active

Do a soft config of the device. (wake up the device)

Do a mesh config of the device.

Reboot the HCx

Wait a few minutes.

Try to update the device

 

 If update fails.

Bring the device closer to the HCx approx 1 mtr.

Do a mesh reconfig.

Try to update again.

 

 

Edited September 2, 2020 by Flash

[Zembaty 1]

Hi All,

Please check how did you add your Heat Controller? As secure or not.

I had the same problem when I added it as secure. I found solution on Polish forum. You have to remove Heat Controller and add it back as non-secure.

Finally I did successful upgrade - after 8-10 tries... and other errors... but possibly distance from HC2 is a key. HC2 i 2 levels higher... but it works... you have to be patient and use non-secure Z-WAVE connection.

I hope it will help. 

[person2000 1]

5 hours ago, Zembaty said:

Hi All,

Please check how did you add your Heat Controller? As secure or not.

I had the same problem when I added it as secure. I found solution on Polish forum. You have to remove Heat Controller and add it back as non-secure.

Finally I did successful upgrade - after 8-10 tries... and other errors... but possibly distance from HC2 is a key. HC2 i 2 levels higher... but it works... you have to be patient and use non-secure Z-WAVE connection.

I hope it will help. 

 

Thank you @Zembaty, this has solved the problem. 

[jgilabert 0]

Please login or register to see this attachment.

[Aaron1064 0]

On 6/20/2020 at 9:40 AM, jgilabert said:

Trying to upgrade from version 4.5 to version 4.7 I get the following error:

Status: fail - file size error. contact fibaro support.

I'm having this problem again and again, ever heard anything from support?

 

[jgilabert 0]

Just remove the device and add it using the above configuration. Then upgrade works fine

[ryce358 0]

On 9/3/2020 at 3:04 PM, Zembaty said:

Hi All,

Please check how did you add your Heat Controller? As secure or not.

I had the same problem when I added it as secure. I found solution on Polish forum. You have to remove Heat Controller and add it back as non-secure.

Finally I did successful upgrade - after 8-10 tries... and other errors... but possibly distance from HC2 is a key. HC2 i 2 levels higher... but it works... you have to be patient and use non-secure Z-WAVE connection.

I hope it will help. 

This worked for me too, thanks