Welcome to Smart Home Forum by FIBARO

Dear Guest,

as you can notice parts of Smart Home Forum by FIBARO is not available for you. You have to register in order to view all content and post in our community. Don't worry! Registration is a simple free process that requires minimal information for you to sign up. Become a part of of Smart Home Forum by FIBARO by creating an account.

As a member you can:

Start new topics and reply to others
Follow topics and users to get email updates
Get your own profile page and make new friends
Send personal messages
... and learn a lot about our system!

Regards,

Smart Home Forum by FIBARO Team

Guest Message by DevFuse

FGS-224 Q2 auto OFF problem and Lock

Asked by jmconstans,
July 24, 2020

Followers 0

Question

jmconstans 0

- Share

Posted July 24, 2020 (edited)

Hi,

when i change parameter 150 to 2 and 154 to 10 for example, Q1 is set to momentary with 1s ON. when I try to change with same value on Q2 (parameter 151 and 155) , Q2 is always set as standard mode.

And also if Q1 and Q2 are set in standard operation , lock enabled works well but if i change Q1 to auto OFF, lock doesn't works, curious because i want to avoid 2 outputs ON in same time and even if Q1 is auto OFF, Q1 is momentary ON and if Q2 is ON ... problems

is it a limitation ? a problem of configuration ? an evolution to make on this module ?

Best regards

Edited July 24, 2020 by jmconstans