HC3 doesn't work

[hellkert 0]

Hi,

 

I have the following lamps (the rest is off):

* Installer RED

* Network YELLOW

* Internet RED

* Power YELLLOW

 

I've tried to set HC3 in recovery mode, but I am not able, after holding power button, a while after it blinks from left to right (I release the button) and it turns off.

What should I do?

 

I want to do the following:

1. Press and hold the  button for 15s, release when all indicators blink red at once.
2. Press and hold the  button, release when indicators start to blink a sequence from left to right.
3. When  indicator turns red, open the Recovery Interface in your Internet browser, as you would normally open the Configuration Interface.

Edited February 4, 2023 by hellkert

[SmartHomeEddy 1,005]

If you are using remote connection, please read the forum and just wait. 

[hellkert 0]

Thanks for the answer. Yes, I am using remote connection. What should I read and wahat should I what on?

Edited February 4, 2023 by hellkert

[SmartHomeEddy 1,005]

Just read the latest posts of the forum. And do nothing, just wait for the solution, take a beer, go on a walk in the beautifull nature of Norway, watch a movie. 

[hellkert 0]

Just now, SmartHomeEddy said:

Just read the latest posts of the forum. And do nothing, just wait for the solution, take a beer, go on a walk in the beautifull nature of Norway, watch a movie. 

Haha! Yes I will do it go out   but I can't access the HC3 from my local network neither..