Reset breached device

[GeeMoney 9]

I Have a Mco Home Co2 Sensor 230v Z-Wave Plus device and sometimes one of the sensors get breached.

Good to know of course, but how do I "reset" this device back to it's normal status without forcing a software reset ?

I Can't find it in the device specific settings nor in the alarms or other options.

It seems to automatically get back to a normal status after a couple of days?

[SmartHomeEddy 1,005]

You could use the MCOhome CO2 sensor only to measures (CO2, temperature, humidity and voc) and report to your HC3. You probably use the association and notification for CO2.

 

You could just use the reported values to notify with the HC3 or for example manage your ventilation. (Doesn't work for the voc values btw)

[GeeMoney 9]

On 2/21/2023 at 8:20 AM, SmartHomeEddy said:

You could use the MCOhome CO2 sensor only to measures (CO2, temperature, humidity and voc) and report to your HC3. You probably use the association and notification for CO2.

 

You could just use the reported values to notify with the HC3 or for example manage your ventilation. (Doesn't work for the voc values btw)

 

Hi Eddy,I'm not using the notifications on the device. It's measuring and only reporting to HC3 but on the Parameters there is a field to set a boundary.
This is what I also would like it to be. Except that if the device get's breached, I will check the values and I would like to be able to bring the device back to a normal state.

The icon changes to red if it's breached.

 

So where is the toggle to simply put it in unbleached mode/normale mode ?

 

Please login or register to see this attachment.

Please login or register to see this attachment.

[svaleb 5]

Since I installed fibaro smokesensors I have wanted to test them, but I have not. 

because I dont know how to get them back to "normal".