FGT-001 and Fibaro Home Center 3 - Daylight saving time issue

[EnzoD 0]

Hello,

I have this issue: after the daylight savint time adjustment, the Home Center 3 time was rigthly adjusted (I am in italy so GMT+1 and +1 for DST) but event the climate zone is correctly synch, the FGT-001 change status one hour after, like they haven't received the DST adjiustment.

Has anyone had this problem?

[Fabir 67]

@EnzoDYou can try a soft reconfiguration on the FGT-001. If you use zwave ZW3 engine on you hc3, this could be the reason for this issue. 

[EnzoD 0]

6 hours ago, Fabir said:

@EnzoDYou can try a soft reconfiguration on the FGT-001. If you use zwave ZW3 engine on you hc3, this could be the reason for this issue. 

Hi, so try to reconfigure using z-wave 2? I think that I will lose all configuration and link to scene an so on.

[EnzoD 0]

It works. I haven't loose configuration but I have't changed protocol: do I have to do two times at year?

Iit loose name and link with scene/quickapp because it changes Deviceid: I have to do for all device

[Fabir 67]

@EnzoDNo, I wrote 'Soft Reconfiguration' not Reconfiguration. With soft reconfiguration you shouldn't loose anything. Look below. On the right side is soft reconfiguration. I use this only if a device isn't working as expected.

Please login or register to see this attachment.

[EnzoD 0]

I have't "soft reconfiguration", but i have loos only name

Please login or register to see this attachment.

 

[Fabir 67]

@EnzoDMaybe with ZW3, soft reconfiguration has another description. I don't remember how it was with my hc3 on ZW3. I would use this on the right side in this case. But sometimes, you need to start a reconfiguration to solve the issue with the device.

[m.roszak 541]

I have reported the issue to the developers.

As for reconfiguration, in ZW3.0 there is only one available but it keeps the names, IDs and other device properties like the old soft-reconfiguration.
It may change those only when support for the device was rewritten or changed. 

[Gaston in t Veld 0]

I have exactly the same issue.  All zones with Fibaro heat controllers have a delay of one hour since DST. Does anyobody in the meantime know if a reconfiguration solved the problem?

[EnzoD 0]

The reconfiguration solved the issue. In the meantime the support wrote me asking to try this:

Please, go to Settings -> Climate -> open your Heating plan and change the time for a few minutes -> click save -> change the time as it was before -> click save one more time.
It should refresh the time of your Heating plan.