Welcome to Smart Home Forum by FIBARO
Search the Community
Showing results for tags 'master/slave'.
Hi , I am using both HC2 and HCL in master slave mode. and i tried to activate alarm panel to take actions in arm mode. first, i selected emergency lights , close blinds and send notification and tested it and it worked good. this situation was before adding any other scenes to the system. i activated the alarm panel in the HC2 (master controller) only . After adding several scenes ( Ex: scenes to open and close lights according to motion detection and LUX in several areas ) , i tried to re test the alarm panel by arming the motion sensors in my system and try to breach any of them. when i did so in the 1st trail only the blinds closed but no notifications sent and the emergency lights did not work as well. i tried to reset the alarm panel and deactivate all actions and re enable it again. when i did so nothing of actions took place. Hint : i have several scenes take place several rimes and always there is notification to alarm that that scenes run sequently more than the number of runs i set in each scene ( 10 times ) my question : is this delay due to these scenes which run a lot or this is a bug in system ? i am using the latest update in both controlled ( not the beta one )