Welcome to Smart Home Forum by FIBARO
Search the Community
Showing results for tags 'singleswitch'.
Hello Fibaro community ! I am trying to pair switch FGS-211 with Fibaro Home Center 3 (not the lite version) as my old Vera died and I have to reconfigure all z-wave devices. I could not de-associate FGS-211 from older controller as it died, so I wen't through reset procedure (3 seconds push on B-pin after power on). Now I am trying to associate it with the new Fibaro HC3 without success. I am enabling inclusion mode, being really close to the controller and nothing happens, the device is not found. I have number of those switches in use, so I would be really sad if they are incompatible with HC3. Note that I have successfully paired FIBARO Roller Shutter 3 and Danfoss Z-wave thermostat with the main unit. Is this know problem or maybe I should perform some different path to include the device into HC3 rather then simple + and search for z-wave devices? During initial setup my HC3 asked if I want to be on 2.0 or 3.0 (beta) version, of course I selected newest and greatest , maybe that's the problem ?
I have got a Fibaro single switch 2 built in a switch box. I used to operate it using Domoticz, however that system got corrupted and I was not able to restore the database in a fresh install of Domoticz. Therefor I decided to purchase a Fibaro Home Center 2. The system works like a charm and I also want to add the Single switch 2. To do that I understood I have to reset the module using the following steps: Resetting the device: Switch off the mains voltage (disable the fuse). Remove the Switch 2 from the wall switch box. Switch on the mains voltage. Press and hold the B-button to enter the menu. Wait for the visual LED indicator to glow yellow. Quickly release and click the B-button again. After few seconds the device will be restarted, which is signalled with the red LED indicator colour. I think I followed all the steps: shut down the power, removed the switch from the switchbox and pulled out all the wires from the module. Then attached all the wires again, switched the power back on, pushed the B-button for a few seconds until the yellow led turned on, release the B-button and quickly pushed it again...… only I didn't get a red LED indicator telling me the module was restarted and reset. I cannot find the module when I want to add it to my HC2. What did I do wrong? And more important, what do I need to do to be able to factory reset the module and add it to my HC2? Deleting it from Domoticz is not possible anymore, because that system is crashed end not working anymore. I must do it like the method mentioned above.... only I don't know what I do wrong. Pleas help me out.
Hello guys I have 2 single Fibaro switches. One connected to the light and a wall switch and the other one only to a wall switch. I am simulating a 2-way circuit here but should be done on z-wave or HC2 level So both switches should follow each others. I turn on one, the other should be turned one and vise versa Maybe i can use device association in Z-wave but i don't prefer so Any ideas?