Welcome to Smart Home Forum by FIBARO
Search the Community
Showing results for tags 'switching'.
Hi All, I'm in the process of wiring an extension for a spare bedroom and have a situation where I have 3 way light switching. I'm wiring with the Walli switches in mind, but trying to understand if, in a 3-way switching setup, I can install 3 Walli switches in the 3-way switching setup, or if only 1 is permissable / possible, and the other 2 switches must be "non-intelligent" / normal switches. I'm fully aware of how to wire a normal 3-way switch setup using standard household switches, but am a bit lost if I want all the switches to be Walli ones The wiring diagram in the Walli Switch manual for 3-way switching shows the following: Although the diagram is clear, it doesn't really show if switches 2 and 3 can also be Walli switches or not. Anyone had any experience with this?
I have several Fibaro FGD-211 and FGD-212 on Smartthings Hub 2 with Momentary Switches (MK Grid type). When I initially add a dimmer to the hub it works fine on both the wall momentary switch and also with the app and Z-wave control via the hub. But after a few minutes, the hub seems to reconfigure the dimmer parameters(?) so that the wall hardware switch doesn't work at all. The app continues to work fine for control. I note that there are some Device Handlers in the smarttthings community that should solve this problem but don't seem to. This is quite a critical problem as I have dimmers in every room and at the moment I cannot connect them to the hub - otherwise when you walk into the room and use the light switch it doesn't work. Stephen (also posted on Smartthings forum)