Jump to content
  • 0

trouble with some 3rd party PIR's


Question

Not sure if this is 4.100 related but it looks like I have some problems with some 3rd party motions sensors (PIR's). Looks like HC2 registers when the PIR fires a ON command, but it never returns to OFF. 

 

Am I the only one seeing this? 

 

- Everspring SP103

- Z-Wave Philio 4-in-1 Sensor

Link to post
Share on other sites

5 answers to this question

Recommended Posts

  • 0

SP103 is working fine for me. I have four of them, included with 4.09, 4.1 and older versions than 4.09.

All of them are working good and firing OFF command after the configured timeout (this little plastic screw).

Link to post
Share on other sites
  • 0
32 minutes ago, Alex said:

SP103 is working fine for me. I have four of them, included with 4.09, 4.1 and older versions than 4.09.

All of them are working good and firing OFF command after the configured timeout (this little plastic screw).

 

I turned it all the way down, maybe that helps...

Link to post
Share on other sites
  • 0
Guest cag014
3 hours ago, sj3fk3 said:

Not sure if this is 4.100 related but it looks like I have some problems with some 3rd party motions sensors (PIR's). Looks like HC2 registers when the PIR fires a ON command, but it never returns to OFF. 

 

Am I the only one seeing this? 

 

- Everspring SP103

- Z-Wave Philio 4-in-1 Sensor

Had same issue with Aeon/Philio sensors and the problem that they're too far from HC2 (in my case), have added repeater and no issues for last several months.

By the way the problem is in both directions (ON and OFF), but when you're looking at the system the ON condition is more noticeable. (when is OFF you assume everything is fine)

Link to post
Share on other sites
  • 0
On 2-10-2016 at 0:49 PM, cag014 said:

Had same issue with Aeon/Philio sensors and the problem that they're too far from HC2 (in my case), have added repeater and no issues for last several months.

By the way the problem is in both directions (ON and OFF), but when you're looking at the system the ON condition is more noticeable. (when is OFF you assume everything is fine)

My problem with my Phlio 3 in 1 sensors is that without template they perform perfectly but once the soft configuration is done and the template is loaded the motion sensor doesn't work anymore.  And changes made in the template do not 'stick'....

Link to post
Share on other sites
  • 0
Guest cag014
2 minutes ago, wienog said:

My problem with my Phlio 3 in 1 sensors is that without template they perform perfectly but once the soft configuration is done and the template is loaded the motion sensor doesn't work anymore.  And changes made in the template do not 'stick'....

Did you try not to use the template?

Do not check the "Use template for parameters" box.

Capture.PNG

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Answer this question...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...