how parameter walli controller with FGR223 for venetian blinds

[jluc2808 0]

My venetian blinds is driven by a FGR223 as a driver and a walli controller FGWC-201 as button

what are the parameter to set with the FGR223 and the walli controller to manage up/down with short cli/push and slat with long clic/push

 

I tried 2 settings to drive completely the venetian blinds without success.  

 

1rst setting:

I set the FGR223 as a venetian blinds and perform a calibration (the module is marked as calibrated) 

then parameter are setted to 

- 152:  150

- 153: 1

- 154, 155: 10

- 156: 5508

- 157: 5376

 

I set the Walli controler FGWCEU-201: 

- type:  venetian blinds (parameter 20=6)

- direct group association: node.0 group 7, with multichannel with node(FGR223).1

 

with this setting i have 4 problems : 

pb 1.1:  when i short clic on the button of the walli controler (short push) nothing append, i have to make a long clic to move up or down the venetian blinds, as far as i stop pushing the button the blinds stop. 

pb 1.2: when i push th button to rich the open position, after few seconds the blinds move by itself to rich the a position 10cm down. 

pb 1.3: when the blinds and button are waiting for almost several hour without interaction, i need to clic twice on the walli controler, 1rst clic with green response with no move, second clic with green with move (up or down)  

pb 1.4: how could i manage the slat ? 

 

second  setting try with another association: 

- FGR223 as a venetian blinds and perform a calibration (the module is marked as calibrated) - same as 1rst try

- Walli controler FGWCEU-201: 

        - type:  venetian blinds (parameter 20=6)

        - direct group association: node.0 group 6, with multichannel with node(FGR223).1

with this setting when i short the venetian blinds move up or down the final position, and another clic stop the move, but i have 3 problems 

- pb 2.1: when i push th button to rich the open position, after few seconds the blinds move by itself to rich the a position 10cm down. 

- pb 2.2: when the blinds and button are waiting for almost several hour without interaction, i need to clic twice on the walli controler, 1rst clic with green response with no move, second clic with green with move (up or down) 

- pb 2.3: how could i manager the slat only ? 

 

[jluc2808 0]

nobody with this config ?