Welcome to Smart Home Forum by FIBARO
Search the Community
Showing results for tags 'garagedoor'.
I want to control my garage door using Z-wave. I’m thinking about a Relay Switch combined with a Door/Window sensor. I have two wires coming from my garage door opener today. I guess I need a power supply for the Relay Switch. What kind of specification do I need for this? I have a standard wall outlet nearby which I can plug into.
Hi all, Setup - FGR-223 controlling up/DN on a roller door with an IR beam sensor wired to S2 so i don't crush cars. Issue - All works fine but when i trip the IR beam (to simulate a car in the way) the drive signal stops (good) then when i reinstate the beam it is like the FGR-223 will not reset. the only way i can get it to work again it to change parameter 151, save and change it back to 151=4 save and all good until beam trip again. Failed attempted solutions - 1. Changed parameter 151 to 3 and 4 not change. 2. Set parameter 41 to 4 then made a scene on the hold of the button but there is no option to make a scene on the release of a button to restart or reset. 3. Randomly checked and unchecked boxes (surprisingly this did not resolve the issue). Is there any manual for this device that goes more in depth than the basic one found on the website support? Any advice would be appreciated. Thanks in advance.
I have a garagedoor motor which i don't know how to connect The motor only have a place for a wall button. The wall button should get connected to Ground and PB. But how do I connect the Fibaro roller shutter 2, all instructions I can find have 3 places to connect. One button up, one down and one ground... Here is the sheet that shows the board