Welcome to Smart Home Forum by FIBARO
Search the Community
Showing results for tags 'input'.
There are 25 digital pins on the ZUNO but can all of them be used for binary input/output using a Fibaro HC2? Thanks for any advice.
Is it possible to control an RGB led strip AND use the IN4 for sensor reading such as a temperature measurement? The manual is a little sketchy (to me) on what exactly can't be done with the controller when you don't use the INputs for switches to control the RGB.
Hi. I have been using the Fibaro RGBW module together with Vera 3 but I never did get the inputs to work. The module has 4 inputs and 4 outputs, and then one would like to be able to use the controller to control the outputs as RGBW leds and the inputs as inputs. After giving up one Vera 3 I bought Home Center 2 (a bit more expensive). Now I can use the outputs and inputs in some sense. Please help me out with the questions below. One can configure the module in 3 ways, as I can understand it, RGBW, RGB, and Input/Output. When I conf. the module in RGBW or RGB, I get a nice controller in HC2 being able to set outputs and also being able to use the small special programs (Storm, Rainbow etc.). But I can't see any inputs. When I conf. the module as Input/Output, I can use the inputs, but now the RGB output control has disappeared. Why is that? Is it possible to use the fine looking HC2 RGB controller and also use the 4 inputs at the same time? Thank You all