Welcome to Smart Home Forum by FIBARO
Search the Community
Showing results for tags 'recovery mode'.
I have Followed the described process (latest firmwares etc) --> HC3 applied latest backup (moved from HC2) --> configuration steps --> Added static IP --> Reboot --> Stuck! Dashboard/Devices forms hanging like trying to load and never stops) Then into Recovery mode --> only option "Reset Network setting" --> Reboot!! Now it gets funny! Now the system never comes up! All LED's is OK except for "Security" LED, which is blinking!? Only option is turn power off and try again --> never getting any further. When trying to "Reset to factory mode" ON PHYSICAL BUTTON as described in the manual (more than 20 secs) Press button in the back during startup - nothing happens. - was expecting to be able to switch between Static/dynamic IP (blink yellow/green), again it ends up with only the 'Security' LED blinking nothing happens????? The point is that it never gets an IP address and goes online! Is it not possible to do a 'Hard reset' on the box to 'factory settings'? Total swipe and start over? Have anyone seen this issue BR / Allan
Hi there, This morning i'd run the new update for my HC2 but it failed for a few times. I tried to put my hc2 in recovery mode but hold the button for to long, now it is in static IP mode. I've connect my mac directly to the hc2 with a cable and tried to get access with 192.168.81.1 but there is no way to get into the recovery... anyone an idea? Sorry for my bad english
Witam, czy ktoś może mi powiedzieć jak wprowadzić centralkę Home Center w tryb recovery? Jedyna dostępna instrukcja obsługi, woła o pomstę do nieba - powinna być raczej ulotką reklamową.. http://www.fibaro.com/manuals/pl/HCLite/HCL-PL-web.pdf Proszę o wskazówki, bo mam taki komunikat: Backup file error Please Wait Backup file is corrupted. Please try again.