Welcome to Smart Home Forum by FIBARO
Search the Community
Showing results for tags 'switch off'.
QA for full control of PC from HC3 (On, Off, Restart, Sleep and Hibernate states) You will need: 1. PC is connected via Fibaro wall plug (or other device with power measurement) 2. installed application Switch Off 3.5.1 from Airytec on your computer http://www.airytec.com/en/switch-off/get.aspx 3. In Switch Off application - go to menu -> Options -> Remote -> Edit web interface settings -> you have to define your port ie. 28100 and password 4. In PC firewall you have to allow Incoming rule for TCP port that you have defined in SwitchOff application ie.28100 5. Working WakeOnLAN (WOL) on your PC (allowed in PC BIOS and on your net card) Installation: 1. Upload this QA to HC3 2. In QA variables you have to define: - PC_DevID : ID of your PC power plug in HC3 - PCAirytecPort: port define for web interface in SwitchOff application from Airytec - PCAirytecPassw: password define for web interface in SwitchOff application from Airytec - PC_IP_Address: IP address of your PC ie. 192.168.1.10 - PC_MacAddress: MacAddress of your PC for WakeOnLAN (WOL) ie. 4B:BC:24:D1:E5:25 - PC_WOL_Port: Port for WakeOnLAN (WOL) - usually 9 - Level<xxx>PC : power in W for showing correct PC state: power >= LevelRunPC PC state: running power >= LevelSleepPC PC state: sleeping power >= LevelHiberPC PC state: hibernating power >= LevelOffPC PC state: off power = 0 PC state: fully off (power>0 to LevelOffPC also means PC state: off) QA PC version: 0.20 - 13.2.2021 PC.fqa
Hi all I have a simple scene that says that if the night variable is set and if the Porch and Driveway lights are off and if front door is breached, it should switch the Porch and Driveway light on for 300 seconds. I have put the 300 as a value in the device.. however, when I opened the door in the morning, the lights didn't switch on at 6AM but when I returned home at 7AM, they were on. That would mean that what I thought was a setting to keep the lights on for 300 seconds is not really that but is a delay of 300 seconds. Am I correct in understanding this ?? Haven't touched the scenes for a while and need to get back into this. I have attached a screenshot of the scene and also the LUA code it generated. How can I change the code to keep the lights on for 300 seconds and then switch off? Thanks in advance. FibaroTestSceneLua.txt